Difference between revisions of "PrintrbotSimple"
From Fixme.ch
(→Software) |
|||
| Line 11: | Line 11: | ||
* OctoPrint slices locally using Cura | * OctoPrint slices locally using Cura | ||
** if you have big models slice on your PC and upload the .gcode | ** if you have big models slice on your PC and upload the .gcode | ||
| + | * A webcam can be attached by USB and will usually be recognized by Motion and available on http://octopi.local:8081 for streaming/image capture | ||
== Running == | == Running == | ||
Revision as of 18:45, 31 May 2014
Contents
Information
- Shop: http://printrbot.com/shop/printrbot-simple/
- How-To: http://help.printrbot.com/c/2014_Printrbot_simple
- It uses 1.75mm filament
- Print area is 150mm x 150mm x 150mm
Software
- A RaspberryPi is attached to our Printrbot with OctoPi operating system (custom Raspbian)
- OctoPrint is accessible on port 80 locally on http://octopi.local/ to control the Simple
- OctoPrint slices locally using Cura
- if you have big models slice on your PC and upload the .gcode
- A webcam can be attached by USB and will usually be recognized by Motion and available on http://octopi.local:8081 for streaming/image capture
Running
- Check the Z level (going at the axe home), the head must slightly touch the bed and not pressing on it
- Check the filament freedom, as the simple doesn't have a spool holder
- Check X and Y rope tension
- Do not aliment the raspberry pi from a PC
