Tron Restore

The project code on Gitorious https://gitorious.org/tron-controls

Description

Remettre en état la borne d'arcarde de Tron

Tron Manual

A faire

• Démonter la borne
• Nettoyer et poncer la borne
• Repeindre
• Coller de nouveaux autocollants
• Brancher un pc engine (ou autre) sur l'écran
• Interfacer un pc avec les commandes de jeu
• Faire marcher l'audio

Components

• Page de référence (Killer List Of Videogames)
• Wells Gardner 19K4906
• PC Engine
• Autocollants originaux: http://www.arcadeoverlays.com/StoreFrontProfiles/deluxeSFshop.aspx?sfid=17232&c=0&search_text=tron&submit=GO
• Manette originale http://groovygamegear.com/webstore/index.php?main_page=product_info&products_id=319&zenid=6fa2e2c526f83c87ca941d4319b8dbdf
• Exemple de restauration: http://driph.com/words/tag/tron/

Moniteur

• Simulating the video out of the Tron board shows that it produces max 0.7V on a 75R output. This means that we should be able to use the VGA voltage levels directly without conversion.
• How to connect a PC to an arcade monitor.
• X11 Configuration
• Arcade VGA
• https://secure.wikimedia.org/wikipedia/en/wiki/VGA_connector
• Mire

To convince the video card that a monitor is present, you need a VGA dummy.

From [1]:

  8.10) Building a 5 BNC cable

This is straightforward, if time consuming and tedious.

The five coaxial cables (75 ohm, RG59 typical) are wired as shown in the
table.  The corresponding VGA connector pin numbers are in ().

     Coax Center         Coax Shield
  --------------------------------------
    Red Video  (1)      Red Return (6)
    Green Video  (2)    Green Return (7)
    Blue Video  (3)     Blue Return (8)
    H Sync (13)         Ground (5,10)
    V Sync (14)         Ground (5,10)

Tie pin 11 (ID0) to Ground to indicate a color monitor.
Leave pin 12 (ID1) open.

Make sure that the lengths of the cables are fairly well matched - to within
a couple of inches - to assure that the 3 color channels line up precisely.
(One foot of cable is about 1.5 to 2 ns of delay which is significant for
a 10 ns dot clock!).

Also note that you will lose your 'Plug-and-Play' capabilities without the
direct control connections to the monitor (or for monitors without these
features).

That's it!

You will wish that your fingers were about 10 times smaller than they are,
however. :-)

Controls

• http://www.usb.org/developers/devclass_docs/HID1_11.pdf
• http://www.usb.org/developers/devclass_docs/Hut1_12.pdf
• http://msdn.microsoft.com/en-us/windows/hardware/gg487464.aspx
• Desktop Page (0x1), Gampad (0x5), Hat switch.

Personnes interessées

• Fred, JB, Simon, François