Changes

PrintrbotSimple

463 bytes added, 10:42, 9 August 2015
/* Running */
* Check the filament freedom, as the simple doesn't have a spool holder
* '''Check X and Y rope tension'''
 
== Calibration ==
* It must be done once in a while
* By manually going on each end X and Y, then homing Z. Always go up a little bit on Z before moving the head
* Bed screws are now locked using some of those screw glue, so it should stay calibrated longer
* Z end stop is glued, it was moving, Z axis should stay calibrated longer
* There is a mechanical problem on the axis, to be calibrated the bed is not leveled compared to the ground, it's working though
== See Also ==
* [[Ultimaker]]
* [[Plastic_recycling]]
ControlGroup, administrator
4,218
edits