Difference between revisions of "PrintrbotSimple"
From Fixme.ch
(Created page with "{| style="width:80%" | __TOC__ |650px |} == Information == * Buy: printrbot.com/shop/printrbot-simple/ * How-To: http://help.printrbot.com/c/2014_Printrbot...") |
|||
| Line 1: | Line 1: | ||
| − | + | [[File:printrbot.png|500px|right]] | |
| − | + | ||
| − | + | ||
| − | + | ||
== Information == | == Information == | ||
* Buy: printrbot.com/shop/printrbot-simple/ | * Buy: printrbot.com/shop/printrbot-simple/ | ||
| Line 10: | Line 7: | ||
* A RaspberryPi is attached to our printrbot | * A RaspberryPi is attached to our printrbot | ||
* [http://octoprint.org/ OctoPrint] is accessible on port 80 locally on http://octopi.local/ to control the Simple | * [http://octoprint.org/ OctoPrint] is accessible on port 80 locally on http://octopi.local/ to control the Simple | ||
| − | * | + | * OctoPrint slices locally using Cura |
| + | ** if you have big models slice on your PC and upload the .gcode | ||
| − | == Running | + | == Running == |
* Check the Z level (going at the axe home), the head must slightly touch the bed and not pressing on it | * Check the Z level (going at the axe home), the head must slightly touch the bed and not pressing on it | ||
* Check the filament freedom, as the simple doesn't have a spool holder | * Check the filament freedom, as the simple doesn't have a spool holder | ||
* Check X and Y rope tension | * Check X and Y rope tension | ||
| + | * Do not aliment the raspberry pi from a PC | ||
== See Also == | == See Also == | ||
* [[Ultimaker]] | * [[Ultimaker]] | ||
* [[Plastic_recycling]] | * [[Plastic_recycling]] | ||
Revision as of 16:33, 30 May 2014
Contents
Information
- Buy: printrbot.com/shop/printrbot-simple/
- How-To: http://help.printrbot.com/c/2014_Printrbot_simple
Software
- A RaspberryPi is attached to our printrbot
- OctoPrint is accessible on port 80 locally on http://octopi.local/ to control the Simple
- OctoPrint slices locally using Cura
- if you have big models slice on your PC and upload the .gcode
Running
- Check the Z level (going at the axe home), the head must slightly touch the bed and not pressing on it
- Check the filament freedom, as the simple doesn't have a spool holder
- Check X and Y rope tension
- Do not aliment the raspberry pi from a PC
