Difference between revisions of "PrintrbotSimple"
From Fixme.ch
(→Slicing) |
|||
| Line 12: | Line 12: | ||
* A webcam is attached by USB and will usually be recognized by Motion and available on http://octopi.local:8081 for streaming/image capture | * A webcam is attached by USB and will usually be recognized by Motion and available on http://octopi.local:8081 for streaming/image capture | ||
| − | == Slicing == | + | == Slicing with Cura == |
* You can't slice on Octoprint, it has been deactivated because it's too slow and you can't crontrol settings | * You can't slice on Octoprint, it has been deactivated because it's too slow and you can't crontrol settings | ||
| − | * Slice on your own PC with Cura | + | * Slice on your own PC with [http://software.ultimaker.com/ Cura] and the following parameters |
[[Image:printrbot-cura.png|300px]] | [[Image:printrbot-cura.png|300px]] | ||
Revision as of 00:52, 27 August 2014
Information
- Shop: http://printrbot.com/shop/printrbot-simple/
- How-To: http://help.printrbot.com/c/2014_Printrbot_simple
- Calibrate: http://3.dmake.me/blog/2014/calibrate-3d-printer/
- It uses 1.75mm filament
- Print area is 150mm x 150mm x 150mm
Software
- A RaspberryPi is attached to our Printrbot with OctoPi operating system (custom Raspbian)
- OctoPrint is accessible on port 80 locally on http://octopi.local/ to control the Simple
- A webcam is attached by USB and will usually be recognized by Motion and available on http://octopi.local:8081 for streaming/image capture
Slicing with Cura
- You can't slice on Octoprint, it has been deactivated because it's too slow and you can't crontrol settings
- Slice on your own PC with Cura and the following parameters
Running
- Check the Z level (going at the axe home), the head must slightly touch the bed and not pressing on it
- Check the filament freedom, as the simple doesn't have a spool holder
- Check X and Y rope tension
- Do not aliment the raspberry pi from a PC
