Difference between revisions of "PrintrbotSimple"
From Fixme.ch
(→Slicing with Cura) |
(→Slicing with Cura) |
||
| Line 15: | Line 15: | ||
* You can't slice on Octoprint, it has been deactivated because it's too slow and you can't crontrol settings | * You can't slice on Octoprint, it has been deactivated because it's too slow and you can't crontrol settings | ||
* Slice on your own PC with [http://software.ultimaker.com/ Cura] and the following parameters | * Slice on your own PC with [http://software.ultimaker.com/ Cura] and the following parameters | ||
| − | [[Image:simple1.png| | + | [[Image:simple1.png|x200px]] |
| − | [[Image:simple2.png| | + | [[Image:simple2.png|x200px]] |
== Running == | == Running == | ||
Revision as of 20:59, 27 August 2014
Information
- Shop: http://printrbot.com/shop/printrbot-simple/
- How-To: http://help.printrbot.com/c/2014_Printrbot_simple
- Calibrate: http://3.dmake.me/blog/2014/calibrate-3d-printer/
- It uses 1.75mm filament
- Print area is 100mm x 100mm x 100mm
Software
- A RaspberryPi is attached to our Printrbot with OctoPi operating system (custom Raspbian)
- OctoPrint is accessible on port 80 locally on http://octopi.local/ to control the Simple
- A webcam is attached by USB and will usually be recognized by Motion and available on http://octopi.local:8081 for streaming/image capture
Slicing with Cura
- You can't slice on Octoprint, it has been deactivated because it's too slow and you can't crontrol settings
- Slice on your own PC with Cura and the following parameters
Running
- Check the Z level (going at the axe home), the head must slightly touch the bed and not pressing on it
- Check the filament freedom, as the simple doesn't have a spool holder
- Check X and Y rope tension
- Do not aliment the raspberry pi from a PC
