Difference between revisions of "PrintrbotSimple"
From Fixme.ch
m (→Running) |
|||
| Line 19: | Line 19: | ||
* Check the filament freedom, as the simple doesn't have a spool holder | * Check the filament freedom, as the simple doesn't have a spool holder | ||
* '''Check X and Y rope tension''' | * '''Check X and Y rope tension''' | ||
| − | |||
== See Also == | == See Also == | ||
* [[Ultimaker]] | * [[Ultimaker]] | ||
* [[Plastic_recycling]] | * [[Plastic_recycling]] | ||
Revision as of 20:02, 6 March 2015
Information
- Shop: http://printrbot.com/shop/printrbot-simple/
- How-To: http://help.printrbot.com/c/2014_Printrbot_simple
- Calibrate: http://3.dmake.me/blog/2014/calibrate-3d-printer/
- It uses 1.75mm filament
- Print area is 100mm x 100mm x 100mm
Software
- The printer is controller with any PC attached to USB and using the Cura software.
- Use the lateste Cura and the "Printrbot simple 2014 maker edition" profile (see param)
Cura parameters
Running
- Check the Z level (going at the axe home), the head must slightly touch the bed and not pressing on it
- Check the filament freedom, as the simple doesn't have a spool holder
- Check X and Y rope tension
