Difference between revisions of "PrintrbotSimple"
From Fixme.ch
| Line 1: | Line 1: | ||
[[File:printrbot.png|500px|right]] | [[File:printrbot.png|500px|right]] | ||
== Information == | == Information == | ||
| − | * | + | * Shop: http://printrbot.com/shop/printrbot-simple/ |
* How-To: http://help.printrbot.com/c/2014_Printrbot_simple | * How-To: http://help.printrbot.com/c/2014_Printrbot_simple | ||
| + | * It uses 1.75mm filament | ||
== Software == | == Software == | ||
| − | * A RaspberryPi is attached to our | + | * A RaspberryPi is attached to our Printrbot |
* [http://octoprint.org/ OctoPrint] is accessible on port 80 locally on http://octopi.local/ to control the Simple | * [http://octoprint.org/ OctoPrint] is accessible on port 80 locally on http://octopi.local/ to control the Simple | ||
* OctoPrint slices locally using Cura | * OctoPrint slices locally using Cura | ||
Revision as of 16:34, 30 May 2014
Contents
Information
- Shop: http://printrbot.com/shop/printrbot-simple/
- How-To: http://help.printrbot.com/c/2014_Printrbot_simple
- It uses 1.75mm filament
Software
- A RaspberryPi is attached to our Printrbot
- OctoPrint is accessible on port 80 locally on http://octopi.local/ to control the Simple
- OctoPrint slices locally using Cura
- if you have big models slice on your PC and upload the .gcode
Running
- Check the Z level (going at the axe home), the head must slightly touch the bed and not pressing on it
- Check the filament freedom, as the simple doesn't have a spool holder
- Check X and Y rope tension
- Do not aliment the raspberry pi from a PC
