Difference between revisions of "PrintrbotSimple"
From Fixme.ch
m (→Running) |
(→Running) |
||
Line 19: | Line 19: | ||
* Check the filament freedom, as the simple doesn't have a spool holder | * Check the filament freedom, as the simple doesn't have a spool holder | ||
* '''Check X and Y rope tension''' | * '''Check X and Y rope tension''' | ||
+ | |||
+ | == Calibration == | ||
+ | * It must be done once in a while | ||
+ | * By manually going on each end X and Y, then homing Z. Always go up a little bit on Z before moving the head | ||
+ | * Bed screws are now locked using some of those screw glue, so it should stay calibrated longer | ||
+ | * Z end stop is glued, it was moving, Z axis should stay calibrated longer | ||
+ | * There is a mechanical problem on the axis, to be calibrated the bed is not leveled compared to the ground, it's working though | ||
== See Also == | == See Also == | ||
* [[Ultimaker]] | * [[Ultimaker]] | ||
* [[Plastic_recycling]] | * [[Plastic_recycling]] |
Revision as of 13:42, 9 August 2015
Information
- Shop: http://printrbot.com/shop/printrbot-simple/
- How-To: http://help.printrbot.com/c/2014_Printrbot_simple
- Calibrate: http://3.dmake.me/blog/2014/calibrate-3d-printer/
- It uses 1.75mm filament
- Print area is 100mm x 100mm x 100mm
Software
- The printer is controller with any PC attached to USB and using the Cura software.
- Use the lateste Cura and the "Printrbot simple 2014 maker edition" profile (see param)
Cura parameters
Running
- Check the Z level (going at the axe home), the head must slightly touch the bed and not pressing on it
- Check the filament freedom, as the simple doesn't have a spool holder
- Check X and Y rope tension
Calibration
- It must be done once in a while
- By manually going on each end X and Y, then homing Z. Always go up a little bit on Z before moving the head
- Bed screws are now locked using some of those screw glue, so it should stay calibrated longer
- Z end stop is glued, it was moving, Z axis should stay calibrated longer
- There is a mechanical problem on the axis, to be calibrated the bed is not leveled compared to the ground, it's working though