PrintrbotSimple

Information

• Shop: http://printrbot.com/shop/printrbot-simple/
• How-To: http://help.printrbot.com/c/2014_Printrbot_simple
• It uses 1.75mm filament

Software

• A RaspberryPi is attached to our Printrbot with OctoPi operating system (custom Raspbian)
• OctoPrint is accessible on port 80 locally on http://octopi.local/ to control the Simple
• OctoPrint slices locally using Cura
  • if you have big models slice on your PC and upload the .gcode

Running

• Check the Z level (going at the axe home), the head must slightly touch the bed and not pressing on it
• Check the filament freedom, as the simple doesn't have a spool holder
• Check X and Y rope tension
• Do not aliment the raspberry pi from a PC

See Also

• Ultimaker
• Plastic_recycling