Difference between revisions of "Vinyl Cutter"
From Fixme.ch
(Created page with "== Description == * Brand: Graphtec * Model Name: Craft ROBO ProS * Model N°: CE5000-40-CRP == Software == There is a Linux software to use the vinyl cutter: '''inkcut'''...") |
|||
| Line 4: | Line 4: | ||
* Model Name: Craft ROBO ProS | * Model Name: Craft ROBO ProS | ||
* Model N°: CE5000-40-CRP | * Model N°: CE5000-40-CRP | ||
| + | |||
| + | [[File:Vinyl_Cutter_1.jpg|200px]] | ||
| + | [[File:Vinyl_Cutter_2.jpg|200px]] | ||
| + | [[File:Vinyl_Cutter_3.jpg|200px]] | ||
== Software == | == Software == | ||
| Line 23: | Line 27: | ||
inkcut | inkcut | ||
| + | [[File:Inkcut_start.png|200px]] | ||
| + | |||
| + | Go to the Device menu > Setup... | ||
| + | |||
| + | [[File:Inkcut_config_general.png|350px]] | ||
| + | [[File:Inkcut_config_connection.png|350px]] | ||
| + | |||
| + | Choose ''Inkcut Generic Driver'' in '''Driver''' on General tab. | ||
| + | Choose the printer name in '''Port''' on Connection tab. | ||
== Material == | == Material == | ||
Use vinyl (Lawl ^^) | Use vinyl (Lawl ^^) | ||
| + | |||
| + | [[File:Vinyl_Cutter_example.jpg|200px]] | ||
Latest revision as of 01:58, 5 January 2019
Description
- Brand: Graphtec
- Model Name: Craft ROBO ProS
- Model N°: CE5000-40-CRP
Software
There is a Linux software to use the vinyl cutter: inkcut
First, you have to install the vinyl cutter as a printer on your system.
Then, install the dependancies:
sudo apt install python3-pip python3-pyqt5 libcups2-dev
Install inkcut:
pip install inkcut
Finaly, in terminal run it:
inkcut
Go to the Device menu > Setup...
Choose Inkcut Generic Driver in Driver on General tab. Choose the printer name in Port on Connection tab.
Material
Use vinyl (Lawl ^^)
