Difference between revisions of "Raspberry Pi fasteners"
From Fixme.ch
(Created page with "solving the fastening of a 3-level stacking: Raspberry Pi 3 model B+ in the middle, 7-inch screen below and StromPi v2 UPS above. thread is M2,5. initially: * screen is atta...") |
|||
| Line 8: | Line 8: | ||
in this case, we are looking for: | in this case, we are looking for: | ||
| − | * long screws and tubular spacers | + | * long screws and tubular spacers. |
| + | ** screw length 15 + 12 = 27 mm ideally, we take 30 mm (standard, threads on the screen can absorb an additional 3 mm) | ||
| + | ** additional set of tubular spacers: length 12 mm | ||
* or "spacer screws" (ideally 7 mm) with long (4 mm instead of 3 mm) male threaded ends | * or "spacer screws" (ideally 7 mm) with long (4 mm instead of 3 mm) male threaded ends | ||
| + | |||
| + | = M2,5 x 30 mm screws and tubular spacers = | ||
Revision as of 18:30, 5 August 2016
solving the fastening of a 3-level stacking: Raspberry Pi 3 model B+ in the middle, 7-inch screen below and StromPi v2 UPS above.
thread is M2,5. initially:
- screen is attached to RPI with "spacer screws" (12 mm + male threaded end 3 mm)
- UPS is attached to RPI with screw (12 mm) with tubular spacers (7 mm).
in this case, we are looking for:
- long screws and tubular spacers.
- screw length 15 + 12 = 27 mm ideally, we take 30 mm (standard, threads on the screen can absorb an additional 3 mm)
- additional set of tubular spacers: length 12 mm
- or "spacer screws" (ideally 7 mm) with long (4 mm instead of 3 mm) male threaded ends
