[[File:printrbot.png|500px|right]]
== Information ==
* The printer has been retired (went back to Rorist), thanks for the good care :)
* Shop: http://printrbot.com/shop/printrbot-simple/
* How-To: http://help.printrbot.com/c/2014_Printrbot_simple
* Check the filament freedom, as the simple doesn't have a spool holder
* '''Check X and Y rope tension'''
== Calibration ==* Do It must be done once in a while* By manually going on each end X and Y, then homing Z. Always go up a little bit on Z before moving the head* Bed screws are now locked using some of those screw glue, so it should stay calibrated longer* Z end stop is glued, it was moving, Z axis should stay calibrated longer* There is a mechanical problem on the Y axis, to be calibrated the bed is not aliment leveled compared to the raspberry pi from ground, it's working though == Testing ==Interesting stuff to print for testing the quality and calibration * http://www.3dbenchy.com/* 5mm steps https://www.thingiverse.com/thing:24238* Single wall (0.4mm) https://www.thingiverse.com/thing:271086* Overhang, bridges, holes and a PClot of tests https://www.thingiverse.com/thing:1363023
== See Also ==
* [[Ultimaker]]
* [[Plastic_recycling]]