Difference between revisions of "PrintrbotSimple"

Revision as of 20:02, 6 March 2015

The printer is controller with any PC attached to USB and using the Cura software.
Use the lateste Cura and the "Printrbot simple 2014 maker edition" profile (see param)

Check the Z level (going at the axe home), the head must slightly touch the bed and not pressing on it
Check the filament freedom, as the simple doesn't have a spool holder
Check X and Y rope tension
Do not aliment the raspberry pi from a PC

@@ Line 8: / Line 8: @@
 == Software ==
-* A RaspberryPi is attached to our Printrbot with [https://github.com/guysoft/OctoPi OctoPi operating system] (custom Raspbian)
+* The printer is controller with any PC attached to USB and using the Cura software.
-* [http://octoprint.org/ OctoPrint] is accessible on port 80 locally on http://octopi.local/ to control the Simple
+* Use the lateste Cura and the "Printrbot simple 2014 maker edition" profile (see param)
-* A webcam is attached by USB and will usually be recognized by Motion and available on http://octopi.local:8081 for streaming/image capture
-== Slicing with Cura ==
+== Cura parameters ==
-* You can't slice on Octoprint, it has been deactivated because it's too slow and you can't crontrol settings
-* Slice on your own PC with [http://software.ultimaker.com/ Cura] and the following parameters
 [[Image:simple1.png|x200px]]
 [[Image:simple2.png|x200px]]