Difference between revisions of "Sensor nodes"
(→Light Sensor) |
|||
| Line 15: | Line 15: | ||
=== Light Sensor === | === Light Sensor === | ||
| + | [[File:Light-B Cu.svg]] | ||
| + | |||
Uses a light dependant resistor | Uses a light dependant resistor | ||
(todo) | (todo) | ||
| + | |||
=== Temperature & Humidity === | === Temperature & Humidity === | ||
(todo) | (todo) | ||
Revision as of 11:06, 17 August 2015
The goal is to have a working, mesh network of sensors (i.e. light, temperature, presence) and actuators (motors to open / close a window, turn lights on and off, etc.). The solution is centred around a raspberry pi that has a NRF24L01+ chip, and works as a central point for gathering all of the data received via the radio. It then builds a webpage transmitting the data in real time and then rules are applied so that we can say, activate one motor if the value of a sensor is below 20° The nodes are based on the ATTiny85 AVR micro-controller and another NRF24L01+ chip.
Contents
Parts
- Raspberry Pi
- x + 1 NRF24L10+ chips, where x is the number of nodes
- x ATTiny
- Tool to flash the ATTiny, this can either be an arduino (using the Arduino as ISP sketch) or a dedicated AVR USB programmer
Sensors
Here is a list of the sensors I made, complete with Kicad files (schematics and PCB layouts)
Light Sensor
Uses a light dependant resistor (todo)
Temperature & Humidity
(todo)
Presence (PIR)
(todo)
Gaz
(todo)
Piezo
(todo)
Sound
(todo)
Actuators
RGB Led strip
Be able to change the color
Window opening
Use a motor to open / close a window
Blinders
(todo)
Sound
(todo)
